Fant 10273 publikasjoner. Viser side 38 av 411:
In this study we produce two urban development scenarios estimating potential urban sprawl and optimized development concerning building construction, and we simulate their influence on air temperature, surface temperatures and human thermal comfort. We select two heat waves representative for present and future conditions of the mid 21st century and simulations are run with the Town Energy Balance Model (TEB) coupled online and offline to the Weather Research and Forecasting Model (WRF). Global and regional climate change under the RCP8.5 scenario causes an increase of daily maximum air temperature in Vienna by 7 K. The daily minimum air temperature will increase by 2–4 K. Changes caused by urban growth or densification mainly affect air temperature and human thermal comfort locally where new urbanisation takes place and does not occur significantly in the central districts. A combination of near zero-energy standards and increasing albedo of building materials on the city scale accomplishes a maximum reduction of urban canyon temperature achieved by changes in urban parameters of 0.9 K for the minima and 0.2 K for the maxima. Local scale changes of different adaptation measures show that insulation of buildings alone increases the maximum wall surface temperatures by more than 10 K or the maximum mean radiant temperature (MRT) in the canyon by 5 K. Therefore, measures to reduce MRT within the urban canyons like tree shade are needed to complement the proposed measures. This study concludes that the rising air temperatures expected by climate change puts an unprecedented heat burden on Viennese inhabitants, which cannot easily be reduced by measures concerning buildings within the city itself. Additionally, measures such as planting trees to provide shade, regional water sensitive planning and global reduction of greenhouse gas emissions in order to reduce temperature extremes are required.
2019
1999
1999
2008
The who, why and where of Norway's CO2 emissions from tourist travel
We present emissions from Norway’s tourist travel by the available transport modes, i.e., aviation, maritime (ferries and cruises) and land-based transport (road and railways). Our study includes detailed information on both domestic and international tourist travel within, from and to Norway. We have coupled statistics from several large surveys with detailed emission data to allow us to separate the purpose of the travel (holiday or business).
Total transport emissions for tourists in 2018 were estimated to be 8 530 kt, equivalent to 19% of the reported Norwegian national emissions. Of these emissions, international tourists visiting Norway were responsible for 3 273 kt , whereas travel by Norwegians accounted for 4 875 kt , most of which occur outside Norway’s reporting obligations. Aviation and maritime transport were found to be the largest emission sources, responsible for 71% and 21% of total emissions, respectively. The reduction due to the COVID-19 pandemic was approximately 60% in 2020, and was sustained throughout the year.
Our study shows that officially reported emissions, as limited to the countries territory, are not suitable for accurate evaluation of transport emissions related to tourism. A consumer or tourist-based calculation gives a marked redistribution of emission responsibility. Our results indicate that emissions from Norwegian residents travelling abroad are 1 602 kt higher than those from tourists coming to Norway. This is driven by frequent trips to popular tourist destinations such as Spain, Thailand, Turkey and Greece. Globally consumer based calculations would shift the responsibility of emissions by tourists to the large wealthy nations, with the most international tourists. The understanding of emission distributed by population group or market support in addition the developing of marketing strategies to attract low emission tourist markets and create awareness among the nations with higher shares of international tourist.
2021
2020
2013
2013
The Volcanic Ash Strategic Initiative Team (VAST) - operational testing activities and exercises. NILU F
2013
2018
2018
2000
2015
2016
2009
2012
2010
2017
This paper describes the Eulerian urban dispersion model EPISODE. EPISODE was developed to address a need for an urban air quality model in support of policy, planning, and air quality management in the Nordic, specifically Norwegian, setting. It can be used for the calculation of a variety of airborne pollutant concentrations, but we focus here on the implementation and application of the model for NO2 pollution. EPISODE consists of an Eulerian 3D grid model with embedded sub-grid dispersion models (e.g. a Gaussian plume model) for dispersion of pollution from line (i.e. roads) and point sources (e.g. chimney stacks). It considers the atmospheric processes advection, diffusion, and an NO2 photochemistry represented using the photostationary steady-state approximation for NO2. EPISODE calculates hourly air concentrations representative of the grids and at receptor points. The latter allow EPISODE to estimate concentrations representative of the levels experienced by the population and to estimate their exposure. This methodological framework makes it suitable for simulating NO2 concentrations at fine-scale resolution (<100 m) in Nordic environments. The model can be run in an offline nested mode using output concentrations from a global or regional chemical transport model and forced by meteorology from an external numerical weather prediction model; it also can be driven by meteorological observations. We give a full description of the overall model function and its individual components. We then present a case study for six Norwegian cities whereby we simulate NO2 pollution for the entire year of 2015. The model is evaluated against in situ observations for the entire year and for specific episodes of enhanced pollution during winter. We evaluate the model performance using the FAIRMODE DELTA Tool that utilises traditional statistical metrics, e.g. root mean square error (RMSE), Pearson correlation R, and bias, along with some specialised tests for air quality model evaluation. We find that EPISODE attains the DELTA Tool model quality objective in all of the stations we evaluate against. Further, the other statistical evaluations show adequate model performance but that the model scores greatly improved correlations during winter and autumn compared to the summer. We attribute this to the use of the photostationary steady-state scheme for NO2, which should perform best in the absence of local ozone photochemical production. Oslo does not comply with the NO2 annual limit set in the 2008/50/EC directive (AQD). NO2 pollution episodes with the highest NO2 concentrations, which lead to the occurrence of exceedances of the AQD hourly limit for NO2, occur primarily in the winter and autumn in Oslo, so this strongly supports the use of EPISODE for application to these wintertime events. Overall, we conclude that the model is suitable for an assessment of annual mean NO2 concentrations and also for the study of hourly NO2 concentrations in the Nordic winter and autumn environment. Further, in this work we conclude that it is suitable for a range of policy applications specific to NO2 that include pollution episode analysis, evaluation of seasonal statistics, policy and planning support, and air quality management. Lastly, we identify a series of model developments specifically designed to address the limitations of the current model assumptions. Part 2 of this two-part paper discusses the CityChem extension to EPISODE, which includes a number of implementations such as a more comprehensive photochemical scheme suitable for describing more chemical species and a more diverse range of photochemical environments, as well as a more advanced treatment of the sub-grid dispersion.
2020